CO0NH--02
B09314
Radiator
Drain
Plug
Engine
Drain
Plug
CO--2
--COOLING COOLANT
REPLACEMENT
CAUTION:
To avoid the danger of being burned, do not remove the ra-
diator cap while the engine and radiator are still hot, as fluid
and steam can be blown out under pressure.
1. DRAIN ENGINE COOLANT
(a) Remove the radiator cap.
(b) Loosen the radiator drain plug (on the right side of the ra-
diator lower tank) and engine drain plug (on the oil cooler
cover), and drain the coolant.
(c) Close the drain plugs.
Torque: 8 N∙m (80 kgf∙cm, 69 in.∙lbf) for Engine
2. FILL ENGINE COOLANT
(a) Slowly fill the system with coolant.
S
Use of improper coolants may damage engine cool-
ing system.
S
Use ”Toyota Long Life Coolant” or equivalent and
mix it with plan water according to the manufactur-
er ’s directions.
S Using of coolant which includes more than 50 %
[freezing protection down to --35˚C(--31˚F)] or 60
% [freezing protection down to --50 ˚C(--58˚F)] of
ethylene-- glycol is recommended but not more than
70 %.
NOTICE:
S
SS
S
Do not use an alcohol type coolant or plain water
alone.
S
SS
S
The coolant should be mixed with plain water (prefer-
ably demineralized water or distilled water).
Capacity:
9.5 liters (10.0 US qts, 8.4 lmp. qts)
(b) Reinstall the radiator cap.
(c) Start the engine, and bleed the cooling system.
(d) Refill the radiator reservoir with coolant until it reaches the
”F” line.
3. CHECK ENGINE COOLANT FOR LEAKS
4. CHECK ENGINE COOLANT SPECIFIC GRAVITY COR-
RECTLY
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Manual
TO MODEL INDEX
1KZ-TE
To Next Page
Loading...
Need help?
General
