Illustration:
what to do and where
21. CHECK PISTON STROKE OF OVERDRIVE BRAKE
(a)
Taskheading: whattodo
SST 09350--30020 (09350--06120)
Set part No. Component partNo.
Detailed text : howtodotask
(b)
Piston stroke: 1.40 — 1.70 mm (0.0551 — 0.0669 in.)
Specification
Place SST and a dial indicator onto the overdrive brake pis-
ton as shown in the illustration.
Measure the stroke applying and releasing the compressed
air (392 —785kPa,4—8kgf/cm
2
or 57 —114 psi) as shown
in the illustration.
IN --2
--INTRODUCTION HOW TO USE THIS MANUAL
The procedures are presented in a step--by-- step format:
S
The illustration shows what to do and where to do it.
S The task heading tells what to do.
S
The detailed text tells how to perform the task and gives other information such as specifications
and warnings.
Example:
This format provides the experienced technician with a FAST TRACK to the information needed. The upper
case task heading can be read at a glance when necessary, and the text below it provides detailed informa-
tion. Important specifications and warnings always stand out in bold type.
6 . RE FE RE NCE S
References have been kept to a minimum. However, when they are required you are given the page to refer
to.
7. SPECIFICATIONS
Specifications are presented in bold type throughout the text where needed. You never have to leave the
procedure to look up your specifications. They are also found in Service Specifications section for quick ref-
erence.
8 . CAUTI O NS , NO TI CE S , HI NTS :
S
CAUTIONS are presented in bold type, and indicate there is a possibility of injury to you or other
people.
S
NOTICES are also presented in bold type, and indicate the possibility of damage to the components
being repaired.
S
HINTS are separated from the text but do not appear in bold. They provide additional information to
help you perform the repair efficiently.
9 . S I UNI T
The UNITS given in this manual are primarily expressed according to the SI UNIT (International System of
Unit), and a lternately expressed in the metric system and in the English System.
Example:
Torque: 30 N∙m (310 kgf∙cm, 22 ft∙lbf)
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Manual
TO MODEL INDEX
1KZ-TE
To Next Page
Loading...
Need help?
General
