LU0I2--01
P12100
CORRECT WRONG
Seal
Packing
P12380
New Gasket
LU --12
--LUBRICATION OIL PUMP
INSTALLATION
1. INSTALL OIL PUMP (TIMING GEAR CASE)
(a) Remove any old packing (FIPG) material and be careful
not to drop any oil o n the contact surfaces of the timing
gear case and cylinder block.
S Using a razor blade and gasket scraper, remove all
the old packing (FIPG) material from the gasket sur-
faces and sealing groove.
S
Thoroughly clean all components to remove all the
loose material.
S
Using a non-- residue solvent, clean both sealing
surfaces.
(b) Apply seal packing to the timing gear case as shown in the
illustration.
Seal packing: Part No. 08826--00080 or equivalent
NOTICE:
Aroid applying an excessive amount to the surface.
S
Install a nozzle that has been cut to a 3 -- 5 mm (0.12
-- 0.20 in.) opening.
S
Parts must be assembled within 3 minutes of ap-
plication. Otherwise the material must be removed
and reapplied.
S
Immediately remove nozzle from the tube and rein-
stall cap.
(c) Place a new gasket into the groove of the timing gear
case as shown in the illustration.
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Manual
CONTINUED
TO MODEL INDEX
1KZ-TE
To Next Page
Loading...
Need help?
General
