B05542
40
30
-- 1 8
Recommended Viscosity (SAE):
TEMPERATURE RANGE ANTICIPATED
BEFORE NEXT OIL CHANGE
-- 2 0
-- 2 9
˚F
˚C16
60
27
80
38
0 100
-- 7
20W--50
20
15W--40
4
10W--30
40
5W--30
LU0BW--02
S04875
Oil Pressure Gauge
Oil Pressure
Switch
S02870
Adhesive
--LUBRICATION OIL AND FILTER
LU --1
OIL AND FILTER
INSPECTION
1. CHECK ENGINE OIL QUALITY
Check the oil for deterioration, entry of water, discoloring or thin-
ning.
If the quality is visibly poor, replace the oil.
Oil grade:
API CF--4 or CF (You may also use API CE or CD)
If you use SAE 10W--30 or higher viscosity oil in extremely low
temperatures, the engine may become difficult to start, so SAE
5W --30 engine oil is recommended.
2. CHECK ENGINE OIL LEVEL
After warming up the engine and then 5 minutes after the en-
gine stops, oil level should be between the ”L” and ”F” marks of
the dipstick.
If low, check for leakage and add oil up to the ”F” mark.
NOTICE:
Do not fill with engine oil above the ”F” mark.
3. CHECK OIL PRESSURE
(a) Using a 24 mm deep socket wrench, remove the oil pres-
sure switch.
(b) Install an oil pressure gauge.
(c) Allow the engine to warm pu to normal operating tempera-
ture.
(d) Check the oil pressure.
Oil pressure:
At idle 29 kPa (0.3 kgf/cm
2
, 4.3 psi) or more
At 3,000 rpm 245 kPa (2.5 kgf/cm
2
,33psi)ormore
(e) Remove the oil pressure gauge.
(f) Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
Part No. 08833--00080, THREE BOND 1344, LOCTITE
242 or equivalent
(g) Reinstall the oil pressure switch.
(h) Start the engine and check for oil leak.
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Manual
TO MODEL INDEX
1KZ-TE
To Next Page
Loading...
Need help?
General
