Z09482
New O--Ring
P12098
CORRECT
WRONG
P11679
P11661
Vacuum
Pipe
EM--38
--ENGINE MECHANICAL TIMING GEAR
3. INSTALL TIMING GEAR COVER
(a) Install a new O-- ring to the timing gear case.
(b) Remove any old packing (FIPG) material and be careful
not to drop any oil o n the contact surfaces of the timing
gear cover and cylinder block.
S
Using a razor blade and gasket scraper, remove all
the old packing (FIPG) material from the gasket sur-
faces and sealing groove.
S Thoroughly clean all components to remove all the
loose material.
S
Using a non-- residue solvent, clean both sealing
surfaces.
(c) Apply seal packing to the timing gear cover as shown in
the illustration.
Seal packing: Part No. 08826--00080 or equivalent
S Install a nozzle that has been cut to a 2 -- 3 mm (0.08
-- 0.12 in.) opening.
S
Parts must be assembled within 5 minutes of ap-
plication. Otherwise the material must be removed
and reapplied.
S
Immediately remove nozzle from the tube and rein-
stall cap.
(d) Install the timing gear cover with the 13 bolts and 2 nuts.
Torque: 13 N∙m (130 kgf∙cm, 9 ft∙lbf)
(e) Connect the vacuum pipe with the bolt, nut and washer.
Torque: 13 N∙m (130 kgf∙cm, 9 ft∙lbf)
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Manual
TO MODEL INDEX
1KZ-TE
CONTINUED
To Next Page
Loading...
Need help?
General
