Toyota 1KZ-TE Repair Manual

P08701
SST (C)
SST (A)
Turn
B09663
Upward
Protrusion
P12622
Approx.
1mm
B00762
--CHARGING ALTERNATOR
CH--13
(h) Turn SST (B) and remove SST (A and B).
4. INSTALL RECTIFIER HOLDER
Install the rectifier holder with the bolt and 4 screws.
Torque: Screw: 1.96 N∙m (20 kgf∙cm, 17.4 in.∙lbf)
Torque: Bolt: 3.9 N∙m (40 kgf∙cm, 34.7 in.∙lbf)
5. INSTALL IC REGULATOR AND BRUSH HOLDER
(a) Install the brush holder cover to the brush holder.
NOTICE:
Be careful of the holder installation direction.
(b) PlacetheICregulatortogetherwiththebrushholderhori-
zontally on the rectifier end frame.
(c) Install the 5 screws untilthere isa clearance of approx.1
mm (0.04 in.) between the brush holder and connector.
Torque: 1.96 N∙m (20 kgf∙cm, 17 in.∙lbf)
(d) Fit the brush holder cover.
6. INSTALL REAR END COVER
(a) Install the end cover with the 3 nuts.
Torque: 4.5 N∙m (46 kgf∙cm, 40 in.∙lbf)
(b) Install the terminal insulator with the nut.
Torque: 4.1 N∙m (42 kgf∙cm, 36 in.∙lbf)
7. CHECK THAT ROTOR ROTATES SMOOTHLY
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Manual
TO MODEL INDEX
1KZ-TE

Toyota 1KZ-TE Specifications

General

Brand	Toyota
Model	1KZ-TE
Category	Engine
Language	English