TP-Link Auranet EAP115-Wall User Manual

5
Chapter 4 Network
On
Network
page you can configure the IP address of the standalone EAP.
Figure 4-1 Network Page
Dynamic/Static: By default, the EAP obtains an IP address from a DHCP server (typically
a router). Select Static to configure IP address manually.
Fallback IP: If the EAP fails to get a dynamic IP address from a DHCP server within
ten seconds, the fallback IP will work as the IP address of the device.
After that, however, the device will keep trying to obtain an IP address
from the DHCP server until it succeeds.
DHCP Fallback
IP/IP MASK:
Enter the fallback IP/IP mask.
DHCP Fallback
Gateway:
Enter the fallback gateway.

TP-Link Auranet EAP115-Wall Specifications

General

Frequency	2.4GHz
Signal Rate	Up to 300Mbps
Button	Reset Button
Certifications	CE, FCC, RoHS
Operating Temperature	0°C to 40°C (32°F to 104°F)
Wireless Standards	IEEE 802.11b/g/n
Power Supply	802.3af PoE
Interface	1 x 10/100 Mbps Ethernet Port (RJ45)
Wireless Functions	Multiple SSIDs
Wireless Security	WPA/WPA2, WPA-PSK/WPA2-PSK
Management	SNMP, Web-based Management, Centralized Management
Operating Humidity	10% to 90% non-condensing
Antenna Type	Internal Antenna
Dimensions	86.8 x 86.8 x 30.2 mm