28
value can be either 0 or at least 30. Enter 0 to disable the update.
Be sure to click the Save button to save your settings on this page.
)
Note:
The device will reboot automatically after you click the Save button.
4.6.4 MAC Filtering
Selecting Wireless > MAC Filtering will allow you to set up some filtering rules to control wireless
stations accessing the device, which depend on the station’s MAC address on the following
screen as shown Figure 4-15.
Figure 4-15 Wireless MAC address Filtering
The Wireless MAC Address Filtering feature allows you to control wireless stations accessing the
AP, which depend on the station's MAC addresses.
¾ MAC Address - The wireless station's MAC address that you want to access.
¾ Status - The status of this entry either Enabled or Disabled.
¾ Privilege - Select the privileges for this entry. You may select one of the following Allow /
Deny.
¾ Description - A simple description of the wireless station.
To set up an entry, follow these instructions:
First, you must decide whether the unspecified wireless stations can access the router or not. If
you desire that the unspecified wireless stations can access the router, please select the radio
button Allow the stations not specified by any enabled entries in the list to access,
otherwise, select the radio button Deny the stations not specified by any enabled entries in
the list to access.
To Add a Wireless MAC Address filtering entry, click the Add New… button. The “Add or Modify
Wireless MAC Address Filtering entry" page will appear, shown in Figure 4-16.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
