Triumph Daytona 955i Handbook

101
Maintenance and Adjustment
Rear Light
Bulb Replacement – Daytona
955i
1 Rear light bulb retainer
Remove the seats, to gain access to
the battery and tail light unit.
Disconnect the battery, negative
(black) lead first.
Rotate the bulb holder anti-clockwise
to release.
Replace the bulb. Fit the bulb holder
to the tail light unit and rotate
clockwise to secure.
Refit the seat/cover.
Rear Light Replacement –
Speed Triple
The rear light unit is a sealed,
maintenance free LED unit.
Warning
The bulb becomes hot during use.
Always allow sufficient time for the
bulb to cool before handling. Avoid
touching the glass part of the bulb.
If the glass is touched or gets
dirty, clean with alcohol before re-
use.
ccoo
1
Caution
To avoid cable damage, do not pull
the bulb holder using the cables.
Caution
When reconnecting the battery,
connect the positive (red) lead
first.

Triumph Daytona 955i Specifications

General

Displacement	955 cc
Bore x Stroke	79 x 65 mm
Compression Ratio	12.0:1
Fuel System	Multipoint sequential electronic fuel injection
Transmission	6-speed
Rear Brakes	Single 220 mm disc, 2-piston caliper
Front Tire	120/70 ZR17
Rear Tire	190/50 ZR17
Width	720 mm (28.3 in)
Seat Height	815 mm (32.1 in)
Engine Type	Liquid-cooled, inline 3-cylinder
Max Torque	100 Nm (74 lb-ft) @ 8, 200 rpm
Final Drive	Chain
Frame	Aluminum beam
Front Suspension	43 mm inverted telescopic fork, adjustable
Rear Suspension	Monoshock, adjustable
Front Brakes	Twin 320 mm discs, 4-piston calipers
Fuel Capacity	21 litres (5.5 US gallons)