27
General Information
• Trip meter 2
To reset either of the trip meters,
select and display the trip meter to
be zeroed then press the ‘trip’ and
‘set’ buttons together for 2 seconds.
After 2 seconds, the trip meter on
display will reset to zero.
Clock/Trip Computer
1 Clock/Trip Computer Display
2 ‘Scroll Button’
The clock and trip computer
information appear on the same
display.
The trip computer provides an
indication of fuel consumption,
speed, time and distance, recorded
and calculated since the last reset.
Each display provides the following
information:
Instantaneous Fuel Consumption
An indication of the fuel consumption
at an instant in time.
Average Fuel Consumption
An indication of the average fuel
consumption, calculated from when
the trip computer was last reset.
After a reset the display will show
dashes until 0.1 miles/km has been
covered.
Journey Distance
The total distance travelled, since
the last reset.
Journey Time
The total time elapsed, since the last
reset.
Average Speed
The average speed is calculated from
when the trip computer was last
reset. After a reset the display will
show dashes until 1 mile/km has
been covered.
Maximum Speed
The maximum speed achieved since
the last reset is displayed.
Trip Computer Operation
Display Section
When the ignition is switched on the
clock display is shown. To access the
trip computer information press the
‘scroll’ button.
Press the ‘scroll’ button repeatedly
until the desired display is visible.
The trip display will scroll through in
the order:
•Clock
ccna
1
2