EasyManuals Logo

Triumph Daytona 955i Handbook

Triumph Daytona 955i
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
35
General Information
Right Handlebar
Switches
1 Engine stop switch
2 Starter button
Engine Stop Switch
In addition to the ignition switch
being turned to the 'ON' position, the
engine stop switch must be in the
'run' position for the motorcycle to
operate.
The engine stop switch is for
emergency use. If an emergency
arises which requires the engine to
be stopped, move the engine stop
switch to the stop position.
NOTE
Although the engine stop
switch stops the engine, it
does not turn off all the
electrical circuits and may
cause difficulty in restarting
the engine due to a
discharged battery.
Ordinarily, only the ignition
switch should be used to
stop the engine.
Starter Button
The starter button operates the
electric starter. For the starter to
operate, the clutch lever must be
pulled to the handlebar.
Warning
Do not attempt to adjust the
levers with the motorcycle in
motion as this may lead to loss of
motorcycle control and an
accident.
After adjusting the levers, operate
the motorcycle in an area free
from traffic to gain familiarity with
the new lever setting. Do not loan
your motorcycle to anyone as they
may change the lever setting from
the one you are familiar with
causing loss of control or an
accident.
ccmh
2
1
Caution
Do not leave the ignition switch in
the 'ON' position unless the engine
is running as this may cause
damage to electrical components
and will discharge the battery.

Table of Contents

Other manuals for Triumph Daytona 955i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Triumph Daytona 955i and is the answer not in the manual?

Triumph Daytona 955i Specifications

General IconGeneral
Displacement955 cc
Bore x Stroke79 x 65 mm
Compression Ratio12.0:1
Fuel SystemMultipoint sequential electronic fuel injection
Transmission6-speed
Rear BrakesSingle 220 mm disc, 2-piston caliper
Front Tire120/70 ZR17
Rear Tire190/50 ZR17
Width720 mm (28.3 in)
Seat Height815 mm (32.1 in)
Engine TypeLiquid-cooled, inline 3-cylinder
Max Torque100 Nm (74 lb-ft) @ 8, 200 rpm
Final DriveChain
FrameAluminum beam
Front Suspension43 mm inverted telescopic fork, adjustable
Rear SuspensionMonoshock, adjustable
Front BrakesTwin 320 mm discs, 4-piston calipers
Fuel Capacity21 litres (5.5 US gallons)

Related product manuals