EasyManuals Logo

Triumph Daytona 955i Handbook

Triumph Daytona 955i
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
37
General Information
Fuel Requirement/
Refuelling
Fuel Grade
Your
Triumph
engine is
designed
to use
unleaded fuel and will give optimum
performance if the correct grade of
fuel is used. Always use unleaded
fuel with an octane rating of 95 RON.
Caution
In all countries, except Australia,
Hong Kong, New Zealand, and
South Africa the exhaust system
is fitted with catalytic converters to
help reduce exhaust emission
levels. The catalytic converters can
be permanently damaged if the
motorcycle is allowed to run out of
fuel or if the fuel level is allowed to
get very low. Always ensure you
have adequate fuel for your
journey.
Caution
The use of leaded fuel is illegal in
most countries, states or
territories. Use of leaded fuel will
damage the catalytic converter (if
fitted).
Warning
To help reduce hazards associated
with refuelling, always observe the
following fuel safety instructions:
Petrol (fuel) is highly flammable
and can be explosive under certain
conditions. When refuelling, turn
the ignition switch to the `OFF'
position.
Do not smoke.
Make sure the refuelling area is
well ventilated and free from any
source of flame or sparks. This
includes any appliance with a pilot
light.
Never fill the tank until the fuel
level rises into the filler neck. Heat
from sunlight or other sources may
cause the fuel to expand and
overflow creating a fire hazard.
After refuelling always check that
the fuel filler cap is correctly
closed and locked.
Because petrol (fuel) is highly
flammable, any fuel leak or
spillage, or any failure to observe
the safety advice given above will
lead to a fire hazard, which could
cause damage to property, injury
to persons or death.

Table of Contents

Other manuals for Triumph Daytona 955i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Triumph Daytona 955i and is the answer not in the manual?

Triumph Daytona 955i Specifications

General IconGeneral
Displacement955 cc
Bore x Stroke79 x 65 mm
Compression Ratio12.0:1
Fuel SystemMultipoint sequential electronic fuel injection
Transmission6-speed
Rear BrakesSingle 220 mm disc, 2-piston caliper
Front Tire120/70 ZR17
Rear Tire190/50 ZR17
Width720 mm (28.3 in)
Seat Height815 mm (32.1 in)
Engine TypeLiquid-cooled, inline 3-cylinder
Max Torque100 Nm (74 lb-ft) @ 8, 200 rpm
Final DriveChain
FrameAluminum beam
Front Suspension43 mm inverted telescopic fork, adjustable
Rear SuspensionMonoshock, adjustable
Front BrakesTwin 320 mm discs, 4-piston calipers
Fuel Capacity21 litres (5.5 US gallons)

Related product manuals