Triumph Daytona 955i Handbook

108
Storage
Preparation after
Storage
Charge the battery if necessary, and
install it in the motorcycle.
Fill the fuel tank with fuel.
Change the engine oil and filter.
Check all the points listed in the
daily safety checks section.
Before starting the engine, remove
one of the spark plugs from each
cylinder.
Put side stand down.
Crank the engine on the starter
motor several times until the oil
pressure light goes out.
Replace spark plugs and start
engine.
Check brakes and operation.

Triumph Daytona 955i Specifications

General

Displacement	955 cc
Bore x Stroke	79 x 65 mm
Compression Ratio	12.0:1
Fuel System	Multipoint sequential electronic fuel injection
Transmission	6-speed
Rear Brakes	Single 220 mm disc, 2-piston caliper
Front Tire	120/70 ZR17
Rear Tire	190/50 ZR17
Width	720 mm (28.3 in)
Seat Height	815 mm (32.1 in)
Engine Type	Liquid-cooled, inline 3-cylinder
Max Torque	100 Nm (74 lb-ft) @ 8, 200 rpm
Final Drive	Chain
Frame	Aluminum beam
Front Suspension	43 mm inverted telescopic fork, adjustable
Rear Suspension	Monoshock, adjustable
Front Brakes	Twin 320 mm discs, 4-piston calipers
Fuel Capacity	21 litres (5.5 US gallons)