DS1039-035A 29 LBT8599
5.7.2
5.7.25.7.2
5.7.2 U
UU
U
SE OF
SE OFSE OF
SE OF
S
SS
S
PECIAL
PECIAL PECIAL
PECIAL
C
CC
C
ODES
ODES ODES
ODES
This function allows to send a specific command to a “Special Decoder” module (1039/80) in IPervoice
system. The attendant can activate an output by entering the code assigned during configuration. For
further details, see paragraph “Special Decoder” in chapter “IPervoice system advanced configuration”
of “Installation technical manual” of IPervoice system.
To send a command using a special code operate as follows:
Press the button to activate the respective call data area;
Enter the code on the keyboard;
The code appears in the call data area (3):
Warning: If the switchboard has been configured to manage several IPervoice servers, before
entering the code, select the server to which the special code must be sent with the
pull-down menu on the upper side of the call area, as shown in the following figure:
After entering the code, press the button ;
If the code is correct, it will be sent to the assigned decoder; the display will show the effect in the call
area:
To Next Page
Loading...
Need help?
General
