DS1039-035A 60 LBT8599
6.3.3
6.3.36.3.3
6.3.3 M
MM
M
ULTI
ULTIULTI
ULTI
-
--
-
SERVER
SERVERSERVER
SERVER
CONFIGURATION
CONFIGURATIONCONFIGURATION
CONFIGURATION
This function allows to access Switchboard software multi-server configuration. If there are more than
one IPervoice server, the system is a multi-server system. In this case, each server manages a group of
buildings, stairs and apartments which are grouped into a logical unit called server. Several servers can
communicate among them to extend IPervoice system features. To operate in more than one server,
concierge switchboards must be enabled on respective servers during system installation with IPervoice
FrontEnd. Some registration operations must also be performed on the switchboard. Select the item
“Multi-site configuration” from the menu “Setting” to display the window shown in Figure 47.
Figure 47: Multi-server configuration
In the upper side there is the list of previously registered servers, if present. To perform the first
configuration operate as follows:
Enter the local IP address, which will be used to register to IPervoice servers.
Warning: This address is identified in Switchboard application configuration file with the
parameter ADAPTER_IP (for further information see the paragraph “Installation -
Usage in Systems with more than one Ethernet Interface” on page 6)
Press the button , the server configuration page will be displayed;
To Next Page
Loading...
Need help?
General
