153
Maintenance and service
Dipped beam
Fitting the bulb
1. Install the new bulb. It can only be fitted
in one position.
2. Press the spring clamp up and a little to
the left so that it snaps into place.
3. Press the connector back into position.
4. Reinstall the plastic cover.
5. Reinstall the lamp housing.
Main beam
1. Remove the entire lamp housing.
2. Twist the bulb holder anticlockwise, pull
it out and replace the bulb. (Note how
the bulb holder is positioned.)
3. Reinstall the bulb holder. It can only be
installed one way
Position/parking lamps
1. Pull the bulb holder out using pliers. Do
not pull out the bulb holder by pulling
the electrical cable.
2. Replace the bulb.
3. Press the bulb holder back into position.
It can only be installed one way.
To Next Page
Loading...
Need help?
General
