Webasto BlueCool S Series User Manual

BlueCool S Series 8 Operation
29
8.6 Switching on cooling mode/heating
mode
 For information on switching on the system, see Chapter
8.4.
Switching over to cooling (heating) means selecting an
operating mode which contains cooling (heating).
• F01 = cooling only.
• F02 = only heating (reverse heating operation).
• F03 = automatic toggeling between cooling and
heating (via reverse heating operation).
• F07 = dehumidification (when ship is
unmanned).
F01 and F03 are possible for cooling (F02 and F03 for
heating).
 Press the function button (5) 3 times until "F x" ap-
pears in the display (1).
 Cooling mode: Press the Plus button (2) or Minus but-
ton (3) repeatedly to change the value “Fx” (opera-
ting mode) to “F01” or “F03”.
Heating mode:
Change the value “Fx” (operating mode)
to “F02” or “F03”.
Note: only if no code is activated. Otherwise the code
must be initially entered now!
 Confirm the entry by pressing the "On/Off" button
(6).
8.7 Setting setpoint temperature
Set the setpoint temperature in accordance with your own
preferences.
 Press the Plus button (2) or Minus button (3).
The setpoint temperature is displayed.
 Press the Plus button (2) or Minus button (3) to
change the setpoint temperature.
 Confirm the entry by pressing the "On/Off" button (6)
or wait at least 5 seconds so that the entered value is au-
tomatically adopted.
8.8 Set the fan speed
 For information on switching on the system, see Chapter
8.4.
 Press the fan setting button (4).
The current fan speed is displayed.
 Press the Plus button (2) or Minus button (3) to
change the fan speed.
If the Plus button (2) is pressed again when the highest
speed (5) has already been selected, the automatic fan
mode is switched on and “bA” appears on the digital
display.
Pressing the Minus button (3) exits the automatic fan
mode and returns to the manual mode.
 Confirm the entry by pressing the “On/Off” button (6)
or wait at least 5 seconds so that the entered value is au-
tomatically adopted.
NOTE
The system only cools under the following
conditions:
• Room temperature > 15 °C.
• Sea water temperature < 35 °C.
• Setpoint temperature < room temperature.
NOTE
The system only heats under the following
conditions:
• Room temperature < 29 °C.
• Sea water temperature > 6 °C.
• Set temperature > room temperature.

Webasto BlueCool S Series Specifications

General

Brand	Webasto
Model	BlueCool S Series
Category	Air Conditioner
Language	English