Webasto BlueCool S Series User Manual

BlueCool S Series 10 Overview of Programming Functions
37
10.3.3 Setting level 2
Parameter 0: Undervoltage switch-off
Setting range: 180 to 210
Factory setting: 195
The undervoltage switch-off is defined for a supply voltage
of 230 V. Dropping below the undervoltage threshold for
more than 5 seconds switches off the system. The error
message AAA is displayed.
Parameter 1: Activation or deactivation of IR remote
control
Setting range: 00, 01
Factory setting: 00
To use the optionally available remote control, this value
must be set to 01.
Although the Webasto digital displays are designed so that
interference with most TV models or household appliances
by the remote control is avoided, the user should note that
interactions can occur in certain cases.
In this case, the value should be set to 00.
Parameter 2: Fan type
Setting range: 00 to 02
Factory setting: 00
Both AC fan motors (alternating current) and low-noise EC
fan motors can be used. If electronic silencers are used,
these can also be activated with this parameter.
00 = standard AC fan motor
01 = electronically commutated (EC) fan motor
02 = when optional electronic silencers are used
Parameter 3: Thermostat-controlled fan or
permanently switched-on fan
Setting range: 00, 01
Factory setting: 00
This parameter defines the behaviour of the fan when the
set setpoint temperature is reached in the cabin.
00 = Fan switches off thermostat-controlled when
setpoint temperature is reached.
01 = Fan remains switched on when setpoint temperature
is reached. Only cooling circuit is switched off.
Parameter b5: Fan speed “5”
Setting range: 25 to 100
Factory setting: 100
The speed at fan speed “5” can be set with this parameter.
If this value is adjusted, a permanent humming noise can
result when using an AC fan.
If electronic silencers are used, the speed on the AC fan
cannot be changed.
Parameter b4: Fan speed “4”
Setting range: 25 to 100
Factory setting: 60
The speed at fan speed “4” can be set with this parameter.
If this value is adjusted, a permanent humming noise can
result when using an AC fan.
If electronic silencers are used, the speed on the AC fan
cannot be changed.
Parameter b3: Fan speed “3”
Setting range: 25 to 100
Factory setting: 50
The speed at fan speed “3” can be set with this parameter.
If this value is adjusted, a permanent humming noise can
result when using an AC fan.
If electronic silencers are used, the speed on the AC fan
cannot be changed.
Parameter b2: Fan speed “2”
Setting range: 25 to 100
Factory setting: 40
The speed at fan speed “2” can be set with this parameter.
If this value is adjusted, a permanent humming noise can
result when using an AC fan.
If electronic silencers are used, the speed on the AC fan
cannot be changed.
Parameter b1: Fan speed “1”
Setting range: 25 to 100
Factory setting: 30
The speed at fan speed “1” can be set with this parameter.
If this value is adjusted, a permanent humming noise can
result when using an AC fan.
If electronic silencers are used, the speed on the AC fan
cannot be changed.
ATTENTION
Reducing the value below the factory setting of
195 V can result in damage to the compressor.
ATTENTION
If this parameter is changed without the
corresponding fan type being connected,
malfunctions can occur.
ATTENTION
Decreasing the speed in the fan speeds can
result in the fan no longer being able to start up
from a stop.

Webasto BlueCool S Series Specifications

General

Brand	Webasto
Model	BlueCool S Series
Category	Air Conditioner
Language	English