Installing Additional Memory 85
Procedure for Installing
Additional Memory
This section describes how to install additional
memory on the printer.
Note
• The printer has two memory card slots. Slot 1 already
has the standard Memory 256 MB installed. Use Slot 2
to install additional memory.
• Memory capacity can be expanded to a maximum of
1.5 GB by installing a Memory 1024 MB card in Slot 2
and replacing the memory card in Slot 1 with a Memory
512 MB card.
1. Switch the power off by pressing the < >
side of the power switch.
2. Unplug the power cord from the power outlet
and the printer.
3. Loosen the two screws on the back right side
of the printer.
4. Pull out the handle on the control board and
then carefully pull the control board out of the
printer. Place the control board on a table top
or some other flat surface.
Important
• When pulling out the control board, hold it with both
hands so you do not drop it.
5. Insert the additional memory card into the
M2 slot as shown in the illustration to the
right.
Aligning the notch in the memory card with
the tab in the M2 slot, insert the card straight
into the slot. Next, press the memory card
down firmly into the slot.
Note
• Make sure the additional memory card is inserted
securely as far as it can go.
• When the memory card is installed correctly, the
retaining clips on both ends stand up.
Memory
Insert securely as
far as it can go.
To Next Page
Loading...
Need help?
General