90 A Appendix
14. Press the < > button until [Software
Options] is displayed.
15. Press the < > or <OK> button to select.
The [FeatureEnhance kit] is displayed.
Note
• If the message [Install options unavailable] appears, it
means that the Feature Enhance Kit ROM is not
installed correctly. Re-install the ROM.
16. Press the < > or <OK> button to select.
[Enable kit] is displayed.
17. Press the < > or <OK> button to select.
[Press OK to enable] is displayed.
18. Press the <OK> button to apply the setting.
The setup process starts.
19. When the [Enabled] message appears,
press the <Menu> button to return to the
print screen.
Important
• If the Feature Enhance Kit installed was previously used
on another printer, the message [Serial Number Error]
appears, followed by the serial number of the other
printer. Once you install the Feature Enhance Kit and
enable it with the control panel, that Feature Enhance
Kit is not usable on any other printer. Also, the message
[Failed to enable] will appear if the Feature Enhance Kit
is not installed correctly on the printer.
Installing the Parallel Port
This section describes how to install the Parallel
Port on the printer.
Before performing the following procedure,
assemble the Parallel Port and frame in
accordance with the instruction manual that
comes with the option.
Note
• The clamp that come with the option are not used with
this printer.
1. Switch the power off by pressing the < >
side of the power switch.
System Settings
Software Options
Software Options
FeatureEnhance kit
FeatureEnhance kit
Enable kit
FeatureEnhance kit
Press OK to enable
FeatureEnhance kit
Enabling
…
FeatureEnhance kit
Enabled
Parallel Port (with frame)
Connector conversion cable
To Next Page
Loading...
Need help?
General