Xerox WorkCentre 3315DN System Administrator Guide

Properties
Xerox WorkCentre 3315DN/3325DN/3325DNI
System Administrator Guide
157
TCP/IP
The TCP/IPv4 and TCP/IPv6 pages allow you to configure the TCP/IP settings on the device. For
instructions refer to Network Installation on page 27.
Raw TCP/IP, LPR, IPP
The Raw TCP/IP, LPR IPP page allows you to configure the Raw TCP/IP (Port 9100), LPR (Line Printer
Remote) and IPP (Internet Printing Protocol) settings on the device. For instructions, refer to Windows
Printing on page 57.
Tel ne t
The Telnet page allows you to configure Telnet settings on the device.
1. In the Network Settings link select the Telnet link.
2. Select Enable to enable the Telnet Protocol.
3. Enter the required information to configure the following settings:
• Port Number
•Login ID
•Password
4. Select Apply to save the settings.
WSD
The WSD page allows you to enable the WSD protocol on the device.
1. In the Network Settings link select the WSD link.
2. Select Enable to enable the WSD Protocol.
3. Select Apply to save the settings.
SLP
The SLP page allows you to configure the SLP protocol (Service Location Protocol) on the device.
1. In the Network Settings link select the SLP link.
2. Select Enable to enable the SLP Protocol.
3. Enter the required information to configure the following settings:
• Scope 1, 2 and 3
• Message Type
•Multicast Radius
• Registration Lifetime
4. Select Apply to save the settings.

Xerox WorkCentre 3315DN Specifications

General

Brand	Xerox
Model	WorkCentre 3315DN
Category	All in One Printer
Language	English