KCU105 Board User Guide www.xilinx.com 2
UG917 (v1.4) September 25, 2015
Revision History
The following table shows the revision history for this document.
Date Version Revision
09/25/2015 1.4
Updated FMC HPC Connector J22. Revised Figure 1-23. Updated the binary format for
I2C EEPROM in Table 1-19. Updated the clocks constraints file listing in Appendix D,
Master Constraints File Listing.
06/27/2015 1.3
Updated connectivity information for Quad 226, Quad 227, and Quad 228 in GTH
Transceivers. Updated Figure 1-21 and Figure 1-36. Updated HDMI Video Output,
including updating Figure 1-22 and Tabl e 1- 1 8 .
05/20/2015 1.2.1
Made typographical edits.
05/07/2015 1.2
Updated Table 1-17, Tab l e 1- 2 1, and Figure 1-22.
04/07/2015 1.1
Changed the Si5328C clock multiplier/jitter attenuator to Si5328B throughout,
including updating the frequency range. Added impedance and insertion loss
information to GTH SMA Clock Input, GTH TX and RX SMA Differential Pairs, PCI
Express Endpoint Connectivity, SFP/SFP+ Module Connectors, FMC HPC Connector
J22, and FMC LPC Connector J2. Updated Figure 1-2, Figure 1-8, Figure 1-9,
Figure 1-22, Figure 1-23, Figure 1-29, Figure 1-34, Figure 1-36, Figure A-1,
Figure C-1, and Figure C-2. Changed IIC to I2C throughout. Updated Table 1 - 4 and
Table 1-25. Added Table 1-26, Maxim Power Tool GUI Regulator Settings. Updated
information for J11, J47, and J49 in Tab l e A- 2. Updated callout number in KCU105
Board Zynq-7000 AP SoC XC7Z010 System Controller. Added instructions for
accessing the system controller main menu in Appendix C, System Controller.
Updated Clock Menu section. Updated the KCU105 Board Constraints File Listing in
Appendix D. Updated the KCU105 evaluation kit master answer record number.
12/18/2014 1.0
Initial Xilinx release.
To Next Page
Loading...
Need help?
General
