3-3-2-4. Analog input circuit
DS3-PTA series servo drive cannot support analog input function.
3-3-2-5. Encoder feedback signal
DS3-PTA series servo drive cannot support encoder feedback output function.
3-3-3. Standard wiring example
Refer to chapter 3-1-3 (DS3-PTA series servo drive cannot support encoder).
3-3-4. Regenerative resistor
Refer to chapter 3-1-4.
4 Use the operate panel
4-1．Basic Operation
4-1-1. Functions of operate panel
5-bit LED: Displaying parameter settings, status or alarm.
Power LED POWER: The LED is on when the servo drive is powered on.
Press: Status switch, status return
Press: Increase the value; Press and hold: Increase the value continuously
Press: Decrease the value; Press and hold: Decrease the value continuously
Press: Shift the editing digit; Press and hold: Enter a status, Enter
the operate panel will self-check after power, all the LED will light for 1s.
4-1-2. Basic Mode Switching
The operate panel can display the status, set parameter and run the command by switching the basic
mode.
The running status, auxiliary function, parameter setting, and monitoring are the basic modes. The
modes switch as the below diagram by pressing STATUS/ESC.
To Next Page
Loading...
Need help?
General
