XO FLEX – Instructions for use Operation
44
Figure 56 – Foot control of assistant call
3.24 SOUND GENERATOR AND SOUNDS
The instrument bridge is fitted with a sound generator that indicates events as described below:
Table 4 - Sounds
The unit is turned on and ready to use
You try to do something that does not make sense
Setting saved successfully
A non-urgent event occurred
Computer connection is disconnected
3.25 SYSTEM MESSAGES
The unit generates messages that can be seen from the instrument bridge display.
See details in section 7.
3.26 XO SEAT AND XO STOOL
We recommend you sit in an upright, balanced position with an angle between thighs and upper
body of about 120
o
– see Figure 57.
To maintain a healthy sitting position, it is extremely important to individually adjust
the height and seat angle of the operator’s stool as described in this section!
XO SEAT and XO STOOL are available in two heights: 1) for operators up to about 180 cm tall and
2) for operators who are taller. If your XO SEAT/XO STOOL is too low or too high, it is possible to
replace the gas spring with a shorter or longer version. Please contact your XO authorized service
provider.
If the height difference between the operator and the chairside assistant is more than 10 cm, a
foot-ring may be fitted.
To Next Page
Loading...
Need help?
General
