XO FLEX – Instructions for use Legal
82
11.4 3
RD
PARTY INSTRUMENTS AND ACCESSORIES
Instruments or accessories manufactured by 3
rd
party manufacturers supplied with this product are
supplied under the responsibility of mentioned 3
rd
party manufacturers.
11.5 PRODUCT UPDATES
XO CARE has no obligation to update this product if newer versions or updates are introduced
after the time of delivery.
11.6 FIRMWARE VERSION
The products described in this manual are according to firmware version 4.02.
It is possible to update to newer firmware versions if available. Please contact your XO authorized
service provider.
11.7 APPLICABLE STANDARDS
XO FLEX fulfills requirements of:
• EN 60601-1 – Part 1
• EN 60601-1-2 – Part 1-2
• EN 1640
11.8 ELECTROMAGNETIC EMISSION
XO FLEX is intended for operation in the electromagnetic environment specified below. Please
make sure that the unit is used in such an environment.
Table 15 – EMC information
Electromagnetic environment - guidelines
RF emissions according to
CISPR 11
36.201.1 Conducted emission,
IEC 61000-4-6
The unit uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not
likely to cause any interference in nearby electronic
equipment, and it is improbable that neighboring
electronic devices will be disturbed.
RF emissions according to
CISPR 11 36.201.1 Radiated
emission, IEC 61000-4-3
The unit is intended for use in all facilities, including
domestic areas and in any facilities connected directly
to a public power supply providing electricity to
buildings used for residential purposes.
IEC 61000-3-2
Voltage fluctuations / flicker
according to IEC 61000-3-3
To Next Page
Loading...
Need help?
General
