XO FLEX – Instructions for use Maintenance and repairs
70
If the value is outside of the indicated range or if the test stripe turns blue you must call an XO
authorized service provider to check the water disinfection system.
6.8 MAINTENANCE AND REPLACEMENT OF MAIN FILTER FOR WATER SUPPLY
Please see “Instructions for preventive service and safety inspection” at xo-care.com.
6.9 CUSPIDOR VALVE – CLEANING THE COURSE FILTER
If the unit is equipped with a cuspidor valve, the coarse filter should be cleaned upon notification
(approximately every month):
1. Lower the service panel – see Figure 89
2. Empty the filter house by activating the manual valve button (1) in Figure 89 for 5 seconds
3. Remove the filter (2)
4. Clean the filter
5. Replace the filter
Figure 89 – Manual activation of cuspidor valve (1) and cuspidor valve filter (2)
Amalgam waste is considered hazardous to the environment and should therefore be
disposed of safely and in accordance with regulatory requirements. Remember to
use safety gloves.
6.10 FLUSHING OF CUSPIDOR DRAIN
If the unit is equipped with a cuspidor valve, you may flush the cuspidor drain if necessary as
follows:
1. Lower the service panel – see Figure 89
2. Activate the manual valve (1) button for min. 3s. while you pour clean water in the cuspidor
bowl.
3. After flushing procedure, remove and clean the yellow filter.
6.11 SUCTION HOSES
If the suction hoses dry up, you may hear a noise when activating the suction.
To Next Page
Loading...
Need help?
General
