Separate Transmit Frequency Memories
All memory channels can store independent receive and transmit frequencies, to
accommodate occasional “odd splits” (non-standard offsets) with greater fre-
quency resolution than is available using the “standard” shift feature.
Memory system operation will be detailed in a later section; here is the procedure
for storing and recalling an “odd split” using a Memory channel:
1. First store the receive (repeater output) frequency.
In the VFO mode, tune the transceiver to the de-
sired receive frequency. Now press and hold in
the
[
VFO/MR
]
button on the microphone for one
second. Notice that the display is now blinking.
2. Within five seconds of pressing the
[
VFO/MR
]
button, use the MAIN DIAL knob or microphone’s
[
UP
]
/
[
DWN
]
buttons to select the desired
Memory channel for storage (occupied memory
channels will show the currently-memorized fre-
quency, while open channels will be blank).
3. Now press the
[
VFO/MR
]
button momentarily to
store the receive frequency into the selected
memory.
4. Next store the transmit (repeater input) frequency.
Since you are still in the VFO mode, tune the trans-
ceiver to the desired transmit frequency.
5. Now press and hold the
[
VFO/MR
]
button for one second. The display will
again blink.
6. Press and hold in the PTT switch, and press the
[
VFO/MR
]
button momentarily
while holding in the PTT switch. This will not cause transmission, but rather it
will instruct the transceiver that you are programming a separate transmit fre-
quency into memory.
7. If you tune off the displayed frequency, you can now return to the just-stored
Memory channel by pressing the
[
VFO/MR
]
button momentarily.
To Next Page
Loading...
Need help?
General
