Yaesu FT-90R User Manual

34
FT-90R OPERATING MANUAL
The FT-90R includes a versatile Memory system which makes everyday opera-
tion more efficient. The Memory System provides 180 “standard” memories, plus
two pairs of band-limiting memories, and a one-touch “HOME” channel for each
band.
For ease in recognition of a channel’s function, Alpha-Numeric labels can be ap-
pended to the frequency information.
The discussion below presumes that the function of the microphone’s
[
VFO/MR
]
button is set to the default “ VFO / MR ” configuration. If you have used any of MENU
items 22~26 to assign the “ VFO / MR ” function to another microphone button or
front panel key, use whatever key you have assigned for the “ VFO / MR ” function
when the
[
VFO/MR
]
button is called for in the sections to follow. See page 47 for
details on programming the microphone buttons and front panel keys.
Memory Storage
To store a frequency into memory:
1. In the VFO mode, select the desired frequency, repeater shift, CTCSS tone, TX
power level, and, if this is a packet channel, the desired baud rate (1200/9600).
2. Press and hold in the
[
VFO/MR
]
button on the microphone for one second. The
display will blink; if a frequency is displayed along with a blinking channel
number, this will indicate that the channel already has frequency data stored on it.
3. Within five seconds of pressing the
[
VFO/MR
]
button, use the MAIN DIAL knob
or the microphone’s
[
UP
]
/
[
DWN
]
buttons to select the desired memory channel
for storage. Look for a channel where no data is currently stored, so as not to
over- write channel data you may wish to use.
4. Press the
[
VFO/MR
]
button again, this time momentarily, to store the displayed
data into the selected memory channel slot. The memory label will stop blink-
ing for a second, then will disappear (since you are still operating in the VFO
mode).
Recalling Memories
From the VFO mode, momentarily press the
[
VFO/MR
]
button on the micro-
phone to activate the “Memory” mode.
When more than one memory has been stored, use the MAIN DIAL knob to select a
memory for operation. Alternatively, microphone’s
[
UP
]
or
[
DWN
]
button may be
used to stop or scan through the available memories. When using the microphone’s
buttons, press and release the button to move one step up or down; press and hold
the
[
UP
]
or
[
DWN
]
button for one second to begin memory scanning.
Memory System Operation

Yaesu FT-90R Specifications

General

Brand	Yaesu
Model	FT-90R
Category	Transceiver
Language	English