Menu Selection Details
01ALPH
Function: Enable/disable the Alpha Numeric display.
Available Values: ON/OFF
Default Setting: OFF
Note:
Setting can be set independently on each Memory channel.
02ALPHc
Function: Programming an Alpha/Numeric memory.
See page 36 for details.
Menu Item Function Available Values Default
20LOCK Enable/disable the key-button lock ON/OFF OFF
21PCKT
Set the transceiver's circuitry for the
Packet baud rate to be used
1200/9600 1200
22Pg:
←
Programming the key assignment
TONE
PRI
SCAN UP
SCAN DN
RPTR
REVERSE
T.BURST
TX PWR
HOME CH
VFO/MR
REVERSE
23Pg:→ Programming the key assignment RPTR
24Pg:P1 Programming the [P1] key assignment TONE
25Pg:P2 Programming the [P2] key assignment TX PWR
26Pg:AC Programming the [ACC] key assignment PRI
27RfSql Adjust the RF SQL threshold level
S-3/S-5/S-FULL/
OFF
OFF
28RPTR Setting the Repeater Shift Direction
ARS/Shift -/
Shift +/OFF
ARS
29SCAN Select the Scan-Resume mode BUSY/TIME BUSY
30Shift Set the magnitude of the Repeater Shift 0.00~99.95
※
31SKIP
Enable/disable skipping of a
memory during scanning
SKIP/STOP STOP
32STEP Setting the synthesizer steps
5.0/10.0/12.5/15.0/
20.0/25.0/50.0
※
33TONE Select the CTCSS/DCS Operation Mode
ENC, ENC/DEC
BELL, DCS, OFF
OFF
34TONEf Setting the CTCSS Tone Frequency
39 standard
CTCSS Tones
100.0
35TOT Set the Time-Out Timer OFF/1~60 6
36TxNar Reducing the MIC Gain ON/OFF OFF
37TxPwr Set the Tx Output Power
HIGH/MID1/
MID2/LOW
HIGH
38AM Select the Receiving mode AUTO/AM/INHIBIT AUTO
※Depends on transceiver version.
To Next Page
Loading...
Need help?
General
