50
Recording the receive audio
1. Touch [F MW], and then touch [REC].
If [REC] is not displayed, touch [BACK ←] to display
[REC] and then touch it.
• The display will indicate “RECSTART” and recording
will begin.
• During recording, “
” icon is displayed at the top of
the screen.
• With the factory default settings, the “A-band” re-
ceived audio is recorded.
• Recording will be paused about 3 seconds after the
squelch of the band that is recording is closed. Re-
cording will resume when a signal is received.
• The band or bands to be recorded, and whether or
not to include the transmit audio in the recording may
be selected in the set mode.
Recording is stopped when the transceiver is turned OFF.
2. Touch [F MW], and then touch [REC STOP].
The recording will be stop.
Setting the Recording function
The band or bands to be recorded, and whether or not to include the transmit audio in
the recording may be selected:
1. Press and hold the [DISP] key, and then touch [TX/
RX].
2. Touch [3 AUDIO], and then touch [5 RECORDING].
3. Press the [DISP] key, and then rotate the DIAL knob to
select the band to record.
A: Record the A-band received audio
B: Record the B-band received audio
A+B: Record both A-band and B-band received audio
5 RECORDING
BAND: A
MIC : OFF
To Next Page
Loading...
Need help?
General
