81
z
Inputting the Password to Use the Transceiver
1. Press and hold the Power (Lock) switch to turn the transceiver ON.
The password input screen appears.
2. Use the numeric keypad on the display to input the password.
3. When the valid password is entered, the frequency display screen appears.
Remark If an invalid password is entered, the transceiver is turned OFF automati-
cally.
• If you have forgotten the registered password, carrying out all resetting allows you to turn
on the transceiver without entering the password.
• It should be noted that performing all resetting resets (initializes) all information such as the
information registered to memory channels and various setting values. It is recommended
that the password be written down on paper.
13 Setting the PTT Delay Time PTT DELAY Function
Set a timed delay before actual transmission begins after PTT switch is pressed.
1. Press and hold the [DISP] key, and then touch [CONFIG].
2. Rotate the DIAL, then touch [13 PTT DELAY].
3. Rotate the DIAL knob to select the desired setting.
OFF/20ms/50ms/100ms/200ms
4. Selecting OFF disables the PTT delay time function.
Remark The default setting: OFF
14 Setting the ARS Function RPT ARS Function
Enable or disable the automatic Repeater Shift operation ARS (Repeater operation is
initiated by tuning to the repeater frequency).
1. Press and hold the [DISP] key, and then touch [CONFIG].
2. Rotate the DIAL, then touch [14 RPT ARS].
3. Rotate the DIAL knob to select the desired setting.
ON Enables the ARS function.
OFF Disables the ARS function.
Remark The default setting: ON
15 Setting the Repeater Shift Direction RPT SHIFT Function
Set the TX frequency shift direction for repeater use.
1. Press and hold the [DISP] key, and then touch [CONFIG].
2. Rotate the DIAL, then touch [15 RPT SHIFT].
3. Rotate the DIAL knob to select the desired setting.
SIMPLEX No TX frequency offset.
-RPT Shifts TX to a lower frequency.
+RPT Shifts TX to a higher frequency.
Remark The default setting differs depending frequency
To Next Page
Loading...
Need help?
General
