67
2 DIGITAL
1 Setting the Pop-up Time of the Remote Station Information
Set the time duration to display the remote station information such as the call sign, on
the LCD.
1. Press and hold the [DISP] key, and then touch [TX/RX].
2. Touch [2 DIGITAL].
3. Touch [1 DIGITAL POPUP].
4. Rotate the DIAL knob to select the desired setting.
OFF The remote station information is not displayed.
BND2s to 60s Set the time duration to display the remote station information (2 to
60 seconds).
BND2s / BND4s / BND6s / BND8s / BND10s / BND20s / BND30s /
BND60s
BNDCNT The remote station information is continuously displayed.
Remark The default setting: BAND 10 seconds
2 Displaying Your Location in Digital Mode
Set whether or not to display your location in digital mode.
1. Press and hold the [DISP] key, and then touch [TX/RX].
2. Touch [2 DIGITAL].
3. Touch [2 LOCATION SERVICE].
4. Rotate the DIAL knob to select the desired setting.
ON Displays your location.
OFF Does not display your location.
Remark The default setting: ON
5. For details on the function, refer to the GM Function Instruction Manual.
3 Setting the Standby Beep
Set whether or not to emit the standby beep sound when the remote station completes
transmission.
1. Press and hold the [DISP] key, and then touch [TX/RX].
2. Touch [2 DIGITAL].
3. Touch [3 STANDBY BEEP].
4. Rotate the DIAL knob to select the desired setting.
ON Emits the standby beep sound.
OFF Does not emit the standby beep sound.
Remark The default setting: ON
To Next Page
Loading...
