ENGINE
3-17
NOTE:
If the specified clutch cable free play cannot be
obtained on the handlebar side of the cable,
use the adjusting nut on the engine side.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
Engine side
a. Loosen the locknuts “1”.
b. Turn the adjusting nut “2” in direction “a” or
“b” until the specified clutch cable free play
is obtained.
c. Tighten the locknuts.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS20950
CLEANING THE AIR FILTER ELEMENT
1. Remove:
•Seat
Refer to "GENERAL CHASSIS" on page 4-
1.
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
2. Remove:
• Air filter case cover “1”
• Air filter element “2”
3. Clean:
• Air filter element
(with solvent)
4. Check:
• Air filter element
Damage → Replace.
5. Install:
• Air filter element
• Air filter case cover
CAUTION:
ECA4S81008
Never operate the engine without the air fil-
ter element installed. Unfiltered air will
cause rapid wear of engine parts and may
damage the engine. Operating the engine
without the air filter element will also affect
throttle bodies synchronization, leading to
poor engine performance and possible
overheating.
NOTE:
When installing the air filter element into the air
filter case cover, make sure their sealing sur-
faces are aligned to prevent any air leaks.
6. Install:
•Fuel tank
Refer to "FUEL TANK" on page 7-1.
•Seat
Direction “a”
Clutch cable free play is increased.
Direction “b”
Clutch cable free play is decreased.
Direction “a”
Clutch cable free play is increased.
Direction “b”
Clutch cable free play is decreased.
To Next Page
Loading...
Need help?
General
