WATER PUMP
6-13
5. Install:
• Impeller shaft
• Circlip
• O-ring
• Water pump cover
EAS26590
INSTALLING THE WATER PUMP
1. Install:
• O-ring
• Copper washer
• Water pump assembly “1”
NOTE:
• Align the slit “a” on the impeller shaft with the
projection “b” on the oil pump shaft.
• Lubricate the O-ring with a thin coat of lith-
ium-soap-based grease.
2. Install:
• O-ring
• Water pump inlet hose “1”
• O-rings
• Water pump outlet hose “2”
• Copper washer
NOTE:
• Install the radiator outlet hose with white “a”
mark positioned outside.
• Install the hose clamp with its screw head
pointed to the inner side.
3. Fill:
• Cooling system
(with the specified amount of the recom-
mended coolant)
Refer to "CHANGING THE COOLANT" on
page 3-20.
4. Check:
• Cooling system
Leaks → Repair or replace the faulty part.
5. Measure:
• Radiator cap opening pressure
Below the specified pressure → Replace
the radiator cap.
Refer to "CHECKING THE RADIATOR" on
page 6-3.
1. Straightedge
2. Impeller
Water pump cover bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
Water pump assembly bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
New
New
New
New
New
New
To Next Page
Loading...
Need help?
General
