EasyManuals Logo

Yamaha F115 User Manual

Yamaha F115
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
Trouble Recovery
114
Make sure no one is standing behind
you when pulling the starter rope. It
could whip behind you and injure some-
one.
An unguarded, rotating flywheel is very
dangerous. Keep loose clothing and
other objects away when starting the en-
gine. Use the emergency starter rope
only as instructed. Do not touch the fly-
wheel or other moving parts when the
engine is running. Do not install the
starter mechanism or top cowling after
the engine is running.
Do not touch the ignition coil, spark plug
wire, spark plug cap, or other electrical
components when starting or operating
the motor. You could get an electrical
shock.
EMU43480
Emergency starting engine (F115,
LF115, F115A1, FL115A1)
1. Remove the top cowling.
2. Remove the bolt that is securing the fly-
wheel cover.
3. Lift up the rear of flywheel cover and pull
it forward to remove it.
4. Prepare the engine for starting. For fur-
ther information, see page 70. Be sure
the engine is in neutral and that the clip is
attached to the engine shut-off switch.
The main switch must be “” (on).
5. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
rotor and wind the rope around the fly-
wheel clockwise.
6. Pull the rope slowly until resistance is felt.
7. Remove the rope from the flywheel tem-
porarily.
8. Rewind the rope around the flywheel ap-
proximately 3/4 of a turn clockwise.
ZMU07395
ZMU02334
ON
STARTOFF
ON
STARTOFF
ZMU04589
U63P1DE0.book Page 114 Tuesday, March 29, 2011 7:15 PM
©2019 Yamaha Motor Corporation, U.S.A.

Table of Contents

Other manuals for Yamaha F115

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha F115 and is the answer not in the manual?

Yamaha F115 Specifications

General IconGeneral
Displacement1832cc
Prop Shaft Horsepower115 hp
Alternator Output35 Amp
Gear Ratio2.15:1
Starting SystemElectric
Fuel RecommendationRegular Unleaded (Minimum Pump Octane 87)
Oil RecommendationYamalube 4M
ExhaustThrough Propeller
LubricationWet Sump
SteeringRemote
Cooling SystemWater Cooled
Bore x Stroke81.0 x 88.9 mm
Full Throttle RPM Range5300-6300 rpm
Fuel Induction SystemEFI (Electronic Fuel Injection)
Ignition SystemTCI (Transistor Controlled Ignition)
Weight377 lbs
CoolingWater Cooled
Shaft LengthL = 20 inch, X = 25 inch

Related product manuals