Yamaha F115 User Manual

Operation
76
EMU31742
Stopping boat
WARNING
EWM01510
●
Do not use the reverse function to slow
down or stop the boat as it could cause
you to lose control, be ejected, or impact
the steering wheel or other parts of the
boat. This could increase the risk of se-
rious injury. It could also damage the
shift mechanism.
●
Do not shift into reverse while traveling
at planing speeds. Loss of control, boat
swamping, or damage to the boat could
occur.
The boat is not equipped with a separate
braking system. Water resistance stops it af-
ter the throttle lever is moved back to idle. The
stopping distance varies depending on gross
weight, water surface conditions, and wind di-
rection.
EMU27821
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating at
high speed is not recommended.
EMU42440
Procedure
1. Push and hold the engine stop button or
turn the main switch to “” (off).
N
ZMU04588
U63P1DE0.book Page 76 Tuesday, March 29, 2011 7:15 PM
©2019 Yamaha Motor Corporation, U.S.A.

Yamaha F115 Specifications

General

Displacement	1832cc
Prop Shaft Horsepower	115 hp
Alternator Output	35 Amp
Gear Ratio	2.15:1
Starting System	Electric
Fuel Recommendation	Regular Unleaded (Minimum Pump Octane 87)
Oil Recommendation	Yamalube 4M
Exhaust	Through Propeller
Lubrication	Wet Sump
Steering	Remote
Cooling System	Water Cooled
Bore x Stroke	81.0 x 88.9 mm
Full Throttle RPM Range	5300-6300 rpm
Fuel Induction System	EFI (Electronic Fuel Injection)
Ignition System	TCI (Transistor Controlled Ignition)
Weight	377 lbs
Cooling	Water Cooled
Shaft Length	L = 20 inch, X = 25 inch