Yamaha F115 User Manual

Operation
78
EMU27888
Adjusting trim angle (Power trim and
tilt)
WARNING
EWM00753
●
Be sure all people are clear of the out-
board motor when adjusting the trim an-
gle. Body parts can be crushed between
the motor and the clamp bracket when
the motor is trimmed or tilted.
●
Use caution when trying a trim position
for the first time. Increase speed gradu-
ally and watch for any signs of instability
or control problems. Improper trim an-
gle can cause loss of control.
●
If equipped with a power trim and tilt
switch located on the bottom cowling,
use the switch only when the boat is at a
complete stop with the engine off. Do
not adjust the trim angle with this switch
while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
To raise the bow (trim-out), press the switch
“” (up).
To lower the bow (trim-in), press the switch
“” (down).
Make test runs with the trim set to different an-
gles to find the position that works best for
your boat and operating conditions.
1. Power trim and tilt switch
1. Power trim and tilt switch
1. Power trim and tilt switch
1. Power trim and tilt switch
DN
UP
1
ZMU07381
UP
DN
1
ZMU04231
U63P1DE0.book Page 78 Tuesday, March 29, 2011 7:15 PM
©2019 Yamaha Motor Corporation, U.S.A.

Yamaha F115 Specifications

General

Displacement	1832cc
Prop Shaft Horsepower	115 hp
Alternator Output	35 Amp
Gear Ratio	2.15:1
Starting System	Electric
Fuel Recommendation	Regular Unleaded (Minimum Pump Octane 87)
Oil Recommendation	Yamalube 4M
Exhaust	Through Propeller
Lubrication	Wet Sump
Steering	Remote
Cooling System	Water Cooled
Bore x Stroke	81.0 x 88.9 mm
Full Throttle RPM Range	5300-6300 rpm
Fuel Induction System	EFI (Electronic Fuel Injection)
Ignition System	TCI (Transistor Controlled Ignition)
Weight	377 lbs
Cooling	Water Cooled
Shaft Length	L = 20 inch, X = 25 inch