56
●
UTILITY Mode
●
• Pitch: You can use this setting to add an offset to the system’s pitch; the avail-
able range is -20% to 10%, settable in 1% increments.
• Input: Selects whether the SU10 takes its input from the LINE IN jack or the
MIC INPUT jack (Line or Mic). You will need to set the appropriate
value if you are using the CROSSFADE, EXTERNAL FILTER, or EXTER-
NAL SCRATCH feature.
MIDI Setup [MIDI]
You use this utility to set the SU10’s MIDI parameters. The following diagram
shows the utility structure.
MIDICh [<][>] DevNum [<][>] Local [<][>] RbnNum [<][>]
NoteTbInit? [<][>] NoteTbClr?
MIDI Channel [MIDICh]
Purpose: Sets the MIDI channel.
Values: 1,...,16, Off
Explanation
Selects the channel for both incoming and outgoing MIDI channel messages.
The SU10 attaches the specified channel number to outgoing channel messages
(Note On, Note Off, and Control Change messages). It responds only to those
incoming channel messages (Note On, Note Off, and Channel Volume messages)
that carry the specified channel number.
If the setting is Off, the SU10 does not send or receive channel messages.
MIDI Device Number [DevNum]
Purpose: Sets the SU10 device number for System Exclusive messages.
Values: 1,...,16, All, Off
Explanation
This setting assigns the device number that the SU10 uses for incoming and outgo-
ing data dumps and other system exclusive messages.
1,...,16 The SU10 includes the selected device number in outgoing mes-
sages, and responds only to those incoming message that include
this device number.
To Next Page
Loading...
Need help?
General
