62
●
UTILITY Mode
●
To load from an MDF2:
1. Set the MDF2 to Seq mode. (
Do not
set to MDR mode.)
2. At the SU10, move to the Dump Rcv? screen and press [ENTER] twice to
begin receiving.
3. At the MDF2, press the START/STOP button to begin playback.
To load from a QY300 or QS300:
1. Go the QY300/QS300 and load the first of your four backup song files.
(Remember that backed-up data is contained in four separate song files.)
2. At the SU10, move to the Dump Rcv? screen and press [ENTER] twice to
begin receiving.
3. Begin song playback at the QY300/QS300.
4. When transfer of the song is completed, load the next song file at the
QY300/QS300, and begin song playback again. Continue until all four
files have been sent.
Sample Dump
Use this utility to dump one or more selected samples in MIDI Sample Dump
Standard format, a standard format recognized by a wide variety of synthesizers,
samplers, and MIDI software packages. This utility makes it possible to send indi-
vidual samples to a remote device for replay or editing.
When you enter this utility, the SU10 displays a message such as the following:
MSDSTx
x x?
Procedure
1. Select the sample you want to dump by pressing [+1] or [–1], or by pressing
[BANK] (if necessary) and the appropriate pad. The displayed message changes
to indicate the selected sample. Press [ENTER] to begin transmission.
▼ If the selected pad is empty, the LCD displays the Pad Empty message and waits for you to
select a different pad. Select another sample as described above, or else press [EXIT] to return to
the UTILITY menu.
To Next Page
Loading...
Need help?
General
