Transom plate and hoses
6-18
Bilge strainer check
1. Check the bilge strainer. See “Jet vacuum
bilge draining system check” (3-10).
Transom plate installation
1. Clean the mating surfaces of the transom
plate “1”.
2. Apply silicone sealant to the mating sur-
face of the transom plate “1”.
3. Install the transom plate “1”, washers “2”,
and “3”, and then tighten the nuts “4” to the
specified torque.
Transom plate nut “4”
26 Nm (2.6 kgf·m, 19.2 ft·lb)
To Next Page
Loading...
Need help?
General