4. START-UP PROGRAMMING & OPERATION............. 75
4.1 Section Safety.................................................................. 76
4.2 Using the Digital LED Operator........................................ 79
Keys, Displays, and LEDs.....................................................79
Digital Text Display .............................................................81
LED Screen Displays...........................................................81
LO/RE LED and RUN LED Indications ....................................82
Menu Structure for Digital LED Operator..................................84
4.3 The Drive and Programming Modes ................................ 85
Navigating the Drive and Programming Modes..........................86
Changing Parameter Settings or Values ..................................90
Verifying Parameter Changes: Verify Menu ..............................90
Switching Between LOCAL and REMOTE................................91
Parameters Available in the Setup Group.................................92
4.4 Start-up Flowchart ........................................................... 93
Flowchart: Basic Start-up......................................................93
4.5 Basic Operation ............................................................... 94
Initialize Parameter Values: A1-03..........................................94
Frequency Reference Source: b1-01.......................................94
Run Command Input Selection: b1-02 .....................................96
Stopping Method Selection: b1-03..........................................98
Acceleration/Deceleration: C1-01 to C1-04...............................99
Drive Duty and Carrier Frequency Selection: C6-01 and C6-02 .. 101
Multi-Step Speed Operation (4-Step Speed)........................... 103
E1: V/f Characteristics ....................................................... 107
Motor Parameters: E2-01 to E2-03 ....................................... 110
Digital Output: H2-01 ......................................................... 111
Analog Outputs: H4-01 to H4-03 .......................................... 111
Motor Protection: L1-01 and L1-02 ....................................... 113
Notes on Controlling the Brake for the Hoist Application............ 116
Drive Status Monitors: U1-01 to U4-13 .................................. 118
4.6 Powering Up the Drive ....................................................119
Powering Up the Drive and Operation Status Display ............... 119
V/f Pattern Setting............................................................. 120
4.7
No-Load Operation Test Run ..........................................121
No-Load Operation Test Run............................................... 121
Table of Contents
YASKAWA ELECTRIC TOEP C710606 25D YASKAWA AC Drive J1000 Installation & Start-Up Manual
5
To Next Page
Loading...
Need help?
General
