Yealink CTP18 Administrator's Guide

| Configuring Network Settings | 76
• Configuring Wireless Access Point
• Viewing the Connected Devices
• Adding Connected Devices to the Blocklist
• Removing Devices from the Blocklist
• Disabling the Wireless Access Point
Enabling the Wireless Access Point
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Wireless AP.
• On your VCS: go to More > Settings > Network Setting > Wireless AP > Wireless AP.
For VP59, tap > Settings > Network Setting > Wireless AP > Wireless AP.
•
If CTP20/CTP18 is wired to the VCS devices, on your CTP20/CTP18, tap > Settings > Network
Setting > Host Network > Network > Wireless AP .
2. Enable the Wireless AP.
3. If you already enabled Wi-Fi, select OK to turn it off.
Configuring Wireless Access Point
You can configure the wireless access point for the devices.
Before you begin
Make sure you enable the wireless AP.
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Wireless AP > AP Config.
• On your VCS: go to More > Settings > Network Setting > Wireless AP > Configure AP.
For VP59, tap > Settings > Network Setting > Wireless AP > Configure AP.
•
On your CTP20/CTP18, tap > Settings > Network Setting > Host Network > Network >
Wireless AP > Configure AP.
2. Configure and save the following settings:
Parameter Description Configuration Method
AP Name Configure the name of wireless
AP.
Web user interface
Endpoint
CTP20/CTP18
Security Mode
Configure the security mode of
the wireless AP.
• None
• WPA2-PSK
Default: WPA2-PSK.
Web user interface
Endpoint
CTP20/CTP18

Yealink CTP18 Specifications

General

Aspect ratio	16:10
Display diagonal	8 \
Display resolution	1280 x 800 pixels
Touchscreen technology	Capacitive
Built-in speaker(s)	No
Ethernet LAN	Yes
Mounting type	Wall/Tabletop
Product color	Black, Grey
RJ-45 ports quantity	1
Cables included	LAN (RJ-45)
Power source type	DC
Power consumption (typical)	7 W

Weight and Dimensions

Depth	100 mm
Width	202 mm
Height	151 mm