Symbologies 11 - 59
Codabar (NW - 7)
Parameter # 7
SSI # 07h
Scan one of the following bar codes to enable or disable Codabar.
Set Lengths for Codabar
L1 = Parameter # 24
SSI # 18h
L2 = Parameter # 25
SSI # 19h
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Set lengths for Codabar to any length, one or two discrete lengths, or lengths within a specific
range.The default is Length Within Range: 4 to 55.
Scan one of the following bar codes to select a length option:
•
One Discrete Length - Decode only Codabar symbols containing a selected length. Select the length using
the bar codes in Appendix B, Numeric Bar Codes. For example, to decode only Codabar symbols with 14
characters, scan Codabar - One Discrete Length, and then scan 1, 4. To correct an error or change the
selection, scan Cancel on page B-3.
•
Two Discrete Lengths - Decode only Codabar symbols containing either of two lengths. Select lengths
using the bar codes in Appendix B, Numeric Bar Codes. For example, to decode only Codabar symbols
containing either 2 or 14 characters, scan Codabar - Two Discrete Lengths, and then scan 0, 2, 1, 4. To
correct an error or change the selection, scan Cancel on page B-3.
•
Length Within Range - Decode Codabar symbols with a specific length range. Select lengths using the
bar codes in Appendix B, Numeric Bar Codes. For example, to decode Codabar symbols containing
between 4 and 12 characters, scan Codabar - Length Within Range, and then scan 0, 4, 1, 2. To correct
an error or change the selection, scan Cancel on page B-3.
•
Any Length - Decode Codabar symbols containing any number of characters within the scanner’s capability.
*Enable Codabar
(1)
Disable Codabar
(0)
NOTE When setting lengths, enter a leading zero for single digit numbers.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
