ABB AC500-eCo V3 User Manual

Electromagnetic Compatibility
Immunity against transient interference vol-
tages (burst):
According to IEC 61000-4-4, zone B, crite-
rion B
Supply voltage units (DC) 2 kV
Digital inputs/outputs (24 VDC) 1 kV
Digital inputs/outputs (120 VAC...240 VAC) Relay 2 kV
Ethernet 1 kV
Immunity against the influence of line-con-
ducted interferences (CW conducted):
According to IEC 61000-4-6, zone B, crite-
rion A
Test voltage 20 V pass A
High energy surges According to IEC 61000-4-5, zone B, crite-
rion B
Power supply DC
1 kV CM / 0.5 kV DM
1
)
DC I/O supply
1 kV CM / 0.5 kV DM
1
)
Buses, shielded ETH
AC I/O unshielded
2
) 1 kV DM
1
)
I/O analog, I/O DC unshielded
2
) 1 kV CM
1
)
Radiation (radio disturbance) According to IEC 55011, group 1, class A
1
) CM = Common Mode, DM = Differential Mode
2
) When DC I/O inputs are used with AC voltage, external filters limiting high energy surges to 1
kV CM / 0.5 DM are required to meet requirements according IEC 61131-2.
6.4.6 Mechanical data
Parameter Value
Mounting Horizontal
Degree of protection IP 20 (if all terminal screws are tightened)
Housing Classification V0 according to UL 94
Vibration resistance acc. to EN 61131-2 all three axes (DIN rail mounting)
5 Hz...8.4 Hz, continuous 3.5 mm
8.4 Hz...150 Hz, continuous 1 g
Shock test All three axes
15 g, 11 ms, half-sinusoidal
Mounting of the modules:
DIN rail according to DIN EN 50022 35 mm, depth 7.5 mm or 15 mm
Mounting with screws Screws with a diameter of 4 mm
Fastening torque 1.2 Nm
6.4.7 Approvals and certifications
Information on approvals and certificates can be found in the corresponding chapter of the
Main catalog, PLC Automation.
Device specifications
System data AC500-eCo V3 > Approvals and certifications
2021/06/293ADR010635, 2, en_US156

ABB AC500-eCo V3 Specifications

General

Brand	ABB
Model	AC500-eCo V3
Category	Industrial Equipment
Language	English