To Next Page

To Previous Page

140 ACF5000 FTIR ANALYZER SYSTEM | OI/ACF5000-EN REV. A

Key entry

Configuring key entries

Description

The source of the display element Key entry is one or more Constant

function blocks that is automatically generated during configuration. Upon

"actuation", the output of this function block assumes the value that was

established during configuration.

For the key entry to be effective, the generated function blocks must be linked

using a function block application after the display is configured (see Tech-

nical Information "Function blocks – Descriptions and configuration" for de-

tailed description).

Configuration

The following are to be configured for the display element Key entry

(see page 141)

 the number of keys (1 to 6) – the keys are assigned to the softkeys,

 the key type

 key or

 switch or

 option key,

 the parameters for each key

 label,

 value key released, and

 value key pressed,

 two lines of text that are displayed when the display element is used,

and

 the password level on which the keys can be used.

Procedure

Key entries are made in measurement mode by pressing the number key

that corresponds to the position of the display element on the display and

that is indicated over the display element. A softkey line then appears with

the configured keys (see "Operating by key entry", see page 60). The display

element key entry accordingly represents feedback to the actual key entry.

ABB ACF5000 User Manual

Questions and Answers: