ACF5000 FTIR ANALYZER SYSTEM | OI/ACF5000-EN REV. A 129
Configuration: Display functions
Display features
The display can be configured
In measurement mode the analyzer system screen is freely configurable. A
standard layout is configured on each delivered unit (see below).
Display elements
Display elements are:
the default measured quantities in the analyzer system (sample compo-
nents, auxiliary quantities, current outputs and current inputs), and
freely configured displays of measured quantities as well as value inputs
or key entries.
"Pages"
The screen is divided into "pages", i.e. the display elements are summarized
on pages. Up to six measurement values can be displayed per page.
The pages brought up when scrolling with >> can be displayed.
A value can only be displayed on a single page.
System pages (standard layout)
The analyzer system normally displays its measured values in a fixed se-
quence on the various screen pages. This holds true for the measured quan-
tities of system modules (see page 118), that were added by the user.
Since up to six values can be displayed on a page, the number of system
pages depends on the number of values.
The user cannot delete system pages.
The following table shows the standard system page layout in a analyzer
system with no more than six sample components and variables each.
Page Standard assignment On/Off
1 Sample component measured values in physical units On
2 Sample component measured values in %MRS On
3 Current signals at the analog outputs On
4 Measured values of the auxiliary variables (e.g. flow,
temperature, pressure) in physical units
Off
5 Sample component auxiliary values in %MRS Off
6 Current signals at the analog inputs (if available) On
To Next Page
Loading...
Need help?
General
