ACF5000 FTIR ANALYZER SYSTEM | OI/ACF5000-EN REV. A 9
Device safety and safe operation
The device is designed and tested in accordance with safety standard
EN 61010 Part 1 "Safety requirements for electrical equipment for measure-
ment, control, and laboratory use," and is shipped ready for safe operation.
To maintain this condition and to assure safe operation, read and follow the
safety instructions in this operating instruction. Failure to do so can put
persons at risk and can lead to device damage as well as damage to other
systems and devices.
Protective conductor terminal
The protective ground conductor should be attached to the protective con-
ductor terminal before any other connection is made.
Danger of a disconnected protective ground conductor
The device can be hazardous if the protective ground conductor is inter-
rupted inside or outside the device or if the protective conductor terminal is
disconnected.
Dangers involved in opening the covers
Current-bearing components can be exposed when the covers or parts are
removed, even if this can be done without tools. Current can be present at
some connection points.
Dangers involved in working with an open device
All work on a device that is open and connected to power should only be
performed by trained personnel who are familiar with the dangers involved.
When safe operation can no longer be assured
If it is apparent that safe operation is no longer possible, the device should
be taken out of operation and secured against unauthorized use.
The possibility of safe operation is excluded:
If the device is visibly damaged,
If the device no longer operates,
After prolonged storage under adverse conditions,
After severe transport stresses.
To Next Page
Loading...
Need help?
General
