Mechanical installation of non-pre-assembled units (ACS800-04M)
81
Fastening the drive module by top to the cabinet frame
In addition to the base fastening, it is recommended to fasten the module to the
cabinet also from the fastening points at the top. Refer to Dimensional drawings for
the vertical fastening points.
If the module is not fastened from the back top to the cabinet frame, it must be
fastened from the front top fastening points during transportation or in case of
vibration.
Fastening the drive module to wall (wall-mounted units only, not for base-mounted
units)
Requirements for protection
The drive module must be protected against contact, dust and humidity (see chapter
Technical data in ACS800-04/04M/U4 Hardware Manual [64671006 (English)].
Requirements for the wall
The wall must be as close to vertical as possible, of non-flammable material and
strong enough to carry the weight of the unit. Check that there is nothing on the wall
to inhibit the installation.
Floor
The floor/material below the installation must be non-flammable.
To Next Page
Loading...
Need help?
General
