✶ ✶
RETAIN THE INSTRUMENT CALIBRATION SHEET
✶ ✶
The factory set calibration constants for the analog inputs and analog
outputs are recorded on the instrument calibration sheet. This sheet
should be retained in the event one or more of the constants is
inadvertently changed.
TRADEMARKS:
The following are trademarks of ABB Automation Inc.: F-CIM
ï››
F-TRAN
ï››
EASY-TUNE
ï››
MICRO-DCI
ï››
MicroLink
ï››
SUPERVISOR-PC
ï››
Flexible Control
Strategy
ï››
The following is a registered trademark of General Electric Company: ULTEM 1000
®
The following is a registered trademark of the HART Communication HART
®
Foundation
The following is a registered trademark of Scada Software Corporation SCADA
®
The following are registered trademarks of Microsoft Corporation MS-DOS
®
WINDOWS®
The following is a registered trademark of Reed Devices, Inc. SNAPTRACK
®
All software, including design, appearance, algorithms and source
codes, is copyrighted by ABB Automation and is owned by ABB
Automation or its suppliers.
NOTICE
The instructions given in this manual cover generally the description,
installation, operation, and maintenance of the subject product.
ABB Automation reserves the right to make engineering refinements
that may not be reflected in this bulletin. Should any questions arise
which may not be answered specifically by these instructions, the
questions should be directed to ABB Automation for further detailed
information and technical assistance. The material in this manual is for
informational purposes and is subject to change without notice. ABB
Automation assumes no responsibility for any errors that may appear in
this manual.
Copyright 2000 ABB Automation Inc. [December 2000]
To Next Page
Loading...
Need help?
General
