ABB ControlIT 53MC5000 User Manual

3.12.5 CONFIGURE A MODULE
Refer to Section 3.11 for Keypad function in Module Mode
The navigational sequence would be the following (Refer to Table 3-5)
:
•
Select Module Type (then Module, if there’s more than one Module)
•
Select Page (Skipped when there’s only a single page)
•
Select Parameter
3.12.5.1 Module-Mode ConfigurationProcedure
•
Press the
Mode
button to enter ENGINEER mode
indicated by the appearance of either
CONFIGURE
,
DISPLAY
or
PROGRAM
at the bottom of the display..
•
If
CONFIGURE
does not appear, press F2 until
CON-
FIGURE
appears at the bottom of the display.
•
When
CONFIGURE
is displayed, press F3 to enter the
CONFIGURE
mode.
•
For a Hi-Res display, as shown, press F2 until
MOD-
ULE
appears at the bottom of the display.
•
When
MODULE
is displayed, press F3 to enter the
MODULE
mode.
•
The screen should now appear as shown on the right.
•
Select the desired MODULE type to be configured by
using the keys to navigate to the desired mod-
ule type.
•
In this example, the button was used to navigate to
the
CONTROL
module type as shown to the right.
•
Press F3 to select this Module type.
53MC5000 Process Control Station
3-16

ABB ControlIT 53MC5000 Specifications

General

Brand	ABB
Model	ControlIT 53MC5000
Category	Controller
Language	English